The comms destination bits set the required destination for these devices.
SYSTRAN 6 INVALID CODE SERIAL
These four comms channels are: Serial FPTP (Systran Emulation), GIGe (Gigabit ethernet), UART (via serial at 9600 Baud, no handshake), and the SYNC port that links to other slave/master DHE's. The LCB_Control module supplies four duplex channels of communications with the DHE. Standard Data Destination Codes for Communication Pixel data memory and descrambling logic common to OUV and IR (PIX)Īnalog front end electronics control and pixel acquisition (IR or OUV).
Safety, Control, and telemetry of the power supply board (PSM)Ĭonfiguration data management (eeprom data), LCB clock control and sequencer (CFG)
SYSTRAN 6 INVALID CODE TORRENT
Torrent firmware module addressing Board Select BitĬommunications and digital control of the Torrent DHE The table below identifies the correspondence: Torrent currently supports the use of the lowest order five bits although eight bits can be specified (with minor modification) in the Torrent architecture. There are 10 bits available in this field. This note pretends to fix the identity of the modules selected by each bit of the board select bit field used in the command structure.
SYSTRAN 6 INVALID CODE CODE
Triggers a 'Start Exposure' event in the sequencer with the 8-bit start vectorįirmware Module Addressing and Identity CodesĪs per ICD 6.1 we use a board select code in each command sent to the LCB to address the individual modules that make up the firmware suit loaded to the Virtex part. Writes the 32-bit value to the addressed registerĨ-bit data value (valid range 0x0 through 0xFF) as sequencer start vector Module address (valid range 0x0 through 0xFFFF)ģ2-bit data value (valid range 0x0 through 0xFFFFFFFF) Returns the 32-bit contents of the addressed register (in hex) Module Address (valid range 0x0 through 0xFFFF) Module number (valid range 0x01 through 0xFF) Torrent engineering commands for RS232 link First Fieldġ6-bit vector (valid range 0x0 through 0xFFFF)įorces an Asynchronous Command to synchronize the communication channels after reset Backspace clears the current command (although currently the display looks messy). Fields must be separated by a space or tab character. All address and data values must be expressed in hex.
Upper or lower case characters are recognized. The standard format of 9600 Baud, 8 bits, no parity is supported. The available commands (shown below) are prefixed with the 'plus' (+) character (0x2B) and completed with a 'Line Feed' character (0x0A). The LCB supports an engineering RS232 communication port for engineering use. RS232 Communication Channel Command Codes SYNC clock sources and routing Attribute value
0 kommentar(er)
